 |
 |
| While Color Studio and Speed E-Namel paints may be used on the same types of project surfaces, Color Studio offers a larger color selection, higher solids, greater flexibility and better exterior durability for the ultimate aerosol finish. Color Studio can withstand temperatures up to 250 degrees Fahrenheit. For surfaces that reach higher temperatures, consider using Zynolyte Hi-TEMP or Bar-B-Q enamel. SURFACE PREPARATION: Surfaces to be painted should be clean, dry and free of oil, grease, rust, wax, loose paint and other contaminates. Extremely slick, glossy or previously painted surfaces should be lightly sanded to provide better paint adhesion. Areas with exposed rust should be scraped clean with a scraper or wire brush. Always apply a good-quality primer before painting over wood, bare metal or when changing the color dramatically. Cover adjacent areas to protect them from overspray. Paints should be applied under dry conditions at or near room temperature. Humidity and temperature conditions can have a significant impact on drying times. APPLICATION: Shake can vigorously for one minute to ensure that the contents are mixed thoroughly. Make sure agitator ball is rattling inside the can. Shake occasionally during use. Hold can approximately 12" from surface to be sprayed and apply finish in several thin coats for best results. Applying a single, heavy coat may result in unsightly runs or drips. The second coat of paint should be applied either immediately after the first coat or after the first coat has completely dried. Please refer to the product packaging for specific application procedures and dry times. CLOGGING: If a spray nozzle becomes clogged, rotate the nozzle a quarter turn and back. If this fails, pull the nozzle off the can and run your thumbnail through the slit at the end of nozzle stem. Rinse nozzle in lacquer thinner. NEVER STICK ANY SHARP OBJECT INTO THE OPENING AT THE TOP OF THE CAN. CLEAN UP & STORAGE: Clean aerosol nozzles by turning the can upside and pressing the nozzle until only gas emerges. Store in a cool, dry place away from heat sources and direct sunlight. |
|
|
Aervoe Industries Zynolyte is a registered trademark of the Glidden Company. |